Details
Still running that stock chain driven transfer case? Want to change your driveshaft Bolt pattern but can't find a flange? One of these little goodies should help out. There are no multi drilled flanges available for the Tacoma, V6, or Pre ‘95 Automatic tcases. Inchworm Gear Driveshaft Flange Adapters allow you to bolt up the driveshaft you want to the flange you have. Adapter is 7/8" thick.
Note: There are THREE different adapters to choose from. The adapter that bolts to your flange will provide you with the other two bolt patterns. Choose your flange pattern below:
-Standard Ujoint - 60mm Square Bolt Pattern
-Front CV Pattern
-Turbo Ujoint - 66mm Square Bolt Pattern - Also found on some Rear CVs as well as later model Tacomas and FJ Cruisers.
Bolt Pattern and Typical Application Breakdown
-60mm x 60mm x 8/9mm 1979-1983 U-Joint (can be drilled out to 10mm to match 84-95 u joint style)
-56mm x 64mm x 8/9 mm 1979 - 1983 U-Joint
-60mm x 60mm x 10mm 1984-1995 U-Joint
-60mm x 68.5mm x 10mm 1984-1995 CV Joint/4cyl
-61.5mm x 70mm x 10mm 1988-1995 CV Joint/V6
-66mm x 66mm x 10mm 1995.5-200x Tacoma, Some Tacoma pickups use a 66mm square bolt pattern.
You may also be interested in the following product(s)
Toyota Long Spline Drive Shaft Kit - 10 inchStarting at: $198.55 |
Toyota Gear Driven Transfer Case Rear Disconnect (104101-1-K, 104102-1-K)Starting at: $629.10 |
Triple Drilled Flanges and Dust ShieldsStarting at: $7.84 |
