Samurai Updated Transfer Case Front Output Shaft

Putting in lower transfer case gears and really getting on the throttle can sometimes damage the front output shaft. This results in a loud popping noise under load and is detrimental to the life of the output shaft. Repeated popping of the front output shaft gear will result in gear failure and loss of power to the front axle. In 1994 Suzuki upgraded the output shaft and stopped using the older style shaft that was prone to failure.

These later style shafts are a drop in replacement for 1986-1993 transfer cases. You can see the difference in the picture, the older version is on top and the upgrade on the bottom.  This upgrade is especially good for transfer cases that have lower than stock gearing in them because the lower the gear, the higher the torque load going through the gear.

The front output gear can be installed without full dis-assembly of the transfer case. Only the front output cover needs to be removed to install this gear. Replace your older gear now and keep it in your tool box as a trail spare. Fits 1986-1995 Suzuki Samurai's.