7 Item(s)
-
5-1/2” Jack Extension
$59.00These 5.5” Jack Extensions are designed to work with Craftsmen 2-ton Jacks but fit most floor jacks on the market and drop into the center pin hole. These provide for a sturdy base that are safer to use than that block of wood that you know you shouldn't use!
Learn More -
Dial Gauge Angle Finder
$7.99Need a tool to find your axle pinion angle? These inexpensive angle finders will do a good job at finding where your spring pads need to be welded. Learn More -
Toyota 23MM FJ80 Tie Rod End Taper Taps M23-1.5
Starting at: $21.40
Low Range Off Road is trying really hard to get you the tools you need to do things on your own. We looked long and hard for an inexpensive tap for the Toyota FJ80 Tie Rod End... problem is, no one makes it. You can find 22MM taps easily, but 23 is oddball. These are custom manufactured just for us. Learn More -
Toyota Differential Breather Tap and Drill Bit
$29.99Are you trying to drill and tap your differential for a Toyota Breather? You can with ease now as we have the drill and tap available for it. This tap and drill are sized according to Toyota's differential breathers. If you use this you can even use the differential breather kit we have available on our website. Learn More -
Hydraulic Assist Steering Box Drill and Tap, 1/4" NPT
$19.99Here is the tap you need when drilling and tapping your own steering box. These are usually special order items anyway, so why not get it along with your ram assist kit from Low Range Off Road and save yourself some money on the part and the shipping?
Learn More -
Trail-Gear 1.200" TPF Taper Reamer for Toyota FJ80 Tie Rod Ends (130324)
$46.55This is the perfect taper reamer for reaming out Toyota and Suzuki pitman arms for the larger, more commonly used FJ80 tie rod ends, like the ones offered in our popular high steer kits. Our taper reamer is 1:10 (1" of taper for every 10" of length) and is also expressed as 1.200" TPF (1.200" of taper for every foot of length). The reamer is made from M2 high speed steel with a 1/2" shank diameter for drill press or mill and a 3/8" square end for use with a tap wrench. Anyone can use this tool. You simply ream out the hole in the pitman arm until you can slide the shank of the TRE in, tighten the castle nut, and install the cotter pin. It takes just a few minutes and can be done with hand tools. Learn More -
18mm Drill Bit
$16.32These are sometimes hard to find, and if you are doing your own Toyota project with leaf springs or making your own brackets for 18mm creeper joints- you may need this to get the job done. We special order these and stock them so that you can add it to your order without chasing them down. Learn More
7 Item(s)
